| |
Mixing:
| Chemical Characteristics： |
| Hazardous Components Name |
Concentrartion(%) |
Hazard symbols |
| Polyester Polyol Resin |
82.2% |
N/A |
| Color Pigments |
17.8% |
N/A |
3.、Hazard Identification
| Major Hazard Effect |
- Hazard Effect：
Eye：May cause teardrops or irritation.
Skin：May cause the itch or irritation.
InhaIation：At room temperatuer,vapors are minimal and no obvious
hazard,If heated, it may cause irritation of the eyes,upper respiratiry
tract,and lungs by excessive exposure.
Ingestion：No hazards are anticipated from ingestion incidental
to industrial exposure.
|
| Hazard Warnings for Environment： |
| Physical and Chemical Dangerous: |
| Special Harm: |
| major state: |
| Hazard Category: |
4.First Aid Measures:
| Emergency and First Aid Procedures: |
Inhalation:Remove victim to fresh
air.Give Oxygen or artificial respiration if necessary.
Skin contact:Remove contaminated clothing.Gently remove excess polymer
from skin.Wash by soap or mild detergent with water. Then flush with
large amount of water for at least 15~20 minutes.Get medical attention.
Eye contact:Irrigate with flowing water immediately and continuously
for at least 15~20 minutes.Get medical attention.
Ingestion:Donot induce womition.get prompt medical attention. |
| Major Disease and Harm Effect:： |
| First aid personal protection:： |
| Prompt to Doctor:The manifestations of respiratory
symptoms resulting from acute exposuer may be delayed.May cause respiratory
sensitization No specific antidotes.Symptomatic and supportive care
Treatment is based on judgement of the physician in response to reactions
of the patient. |
5、Fire Fightion Measuer
| Suitable Extionuishing Media:Carbon dioxide,dry
chemical,regular foam,or Water spray. |
| Fire and Extinguishing Media:Carbon
dioxide,dry chemical,regular foam,or water spray. |
| Special extionguishing proceduer:Down-wind personnel
must be evacuated,Keep up-wind,and avoid breathing hazardous vapors.Fight
fire from a safe distance.Do not enter fire area without proper protection. |
| Special protection equipment:People fighting against
polyol-based color paster must be protected by wearing positive perssure
self-contained breathing apparatus and full positive clothing. |
6、Accidental release measures
| Personal protection:Isolate hazard area and keep
unnecessary people away.Wear full protective equipment including respiratiory
equipment during clean up. |
| Emvironmental protection:Evacuate and ventilate
Dike spill to provent entry into water system. |
| Methods for cleaning up:Take up and place into
containers for later disposal.Cover mops and brooms used for this
with plastic and dispose properly (often by incineration).Landfill
solids at permitted sites. |
7、Handling and Storage
| Handling :Observe all state and local regulations
vhen handling with this substance. |
| Storage:Protect form atmospheric moisture,Keep
container closed when not is use,and store in a cool,dry,and well-ventilated
area. |
8、Exposure control/personal protection
| Engineering control:N/A |
Control factor:N/A
Biotic Index:N/A |
Personal Protection Equipent:
Respiratiory Protection:Not expected to present a respiratory hazard
due to normally low vapor pressure.Wher respiratory protection is
required for certain oqerations,use an approved supplied-air respirator.For
emergency and other conditions,use an approved positive pressure self-contained
breathing apparatus.
Hand Protection:It depends on operation to use appropriate protective
gloves.Use safecy glasses.When contact with this material is likely,chemical
goggles are recommended because eye contact may cause pain even though
it is unlikely to cause injury. Skin&Body Protection: Use protective
clothing impervious to this material.Selection of specific items such
as gloves ,boots , apron,or full-body suit will depend on operation. |
| Hygiene procedures :Emergency shower should be
available in the vicinity of work place.Wash hands before eation and
drinking.Use plenty of soap and water for shower after work. |
9、Physical and Chemical Properties /characteristics
| Appearance:Muddy |
Form:Muddy paste |
| color:white |
Odor:Characteristic mild |
| HP value：-N/A |
Boiling Point / Boiling Range:>200.C |
| Decomposition Temperatuer：-N/A |
Flash point:>150.C
Test Method: |
| Spontaneous temperature：N/A |
Explosion Limits：N/A |
| Vapor pressue：-N/A |
Vapor density：-N/A |
| Specific gravity：N/A |
Solubility in water:Insoluble,reacts |
10、Stability and Reactivity
| Stability:Stable under recommended storage conditions |
| Special Conditions of Hazardous Reaction :Avoid
water as it reacts to form heat and CO2.The combinse effect of the
CO2 and heat can produce enough pressure to rupture aclosed container. |
| Conditions to Avoid:Heat sparks,open flame,and
humidity,Heation in the presence of air (Oxygen) to temperature above
100.C may result in the formation of aldehydes. |
| Incompatibility:Water and oxidizers (string fire
and explosion hazard). |
| Hazardous Decomposition Products : Toxic Oxides
of carbon and Nitrogen. |
11.Toxicological Information
| Acute Toxicity：-N/A |
| Local effects ：-N/A |
| Sensitive:Allergic or respiratory sensitization
is possible , but only rarely. |
| Repeated exposures are not anticipated to cause
any additional significant adverse effects. |
| Exceptional effect：-N/A |
12.Ecological Information
| Possibility of Environmental Impact/Move:N/A |
13、Disposal Information
| Disposal Information:Follow all state
and local regulations.Liquids are usually incinerated in a proper
facility.Solids are usually also incinerated or landfilled.Empty drums
should be filled wity water .Let drum stand unsealed for 48hours .Before
diposal drums shoule be drained,triple rinsed,and holed to prevent
re-use.Dispose of drain and rinsefluid according to state and local
laws and regulations.The most commonly accepted method is in an approved
wastewater treatment facility Drums should be disposed of in accordance
with state and local laws and regulations.commonly accepted method
for disposal of plastic drums is disposal in and approved industrial
incinerator or other appropriate incinerator facility.Steel drums
are commonly disposed in and approved landfill after crushing or in
accordance with other approved procedures |
14.Transport Information
| International Transport Regulation：-N/A |
| The United Nations number(Un0-No)：N/A |
| Internal Transport Regulation：-N/A |
| Special transport way and Note：-N/A |
15、Regulation Information
16、Other Information
Reference
|
